Fab Academy at AS220 Labs

October 28, 2009 9:15 AM

Hey FabFolk! It's # 4 :)

by Makeda Stephenson

Hey hey hey Fabulous Folk! Welcome to the virtual expose of my fourth Fab Academy assignment.

1028090941a.jpg

For assignment #4 we were asked to create a press fit construction kit. My form and function goal was a basic set of pieces that would allow freeform construction of almost any shape.

Check it out :)

1021091346.jpg



1021091429.jpg

A Series of un-Unfortunate Events

I tested my initial idea in matteboard and found the combination of strength and flexibility well suited for my project. I wanted to play around with thin plastics but ruled out acrylic because it's too brittle. There were a couple scrap pieces of this white bendy plastic lying around the lab so I thought I'd try it. It worked like a charm. :) Upon further investigation I learned it's called Delrin. Delrin is an industrial strength plastic thats easy to lasercut and is used for stamps.

I originally created my design for a .05" thickness material. The Delrin sheet I had is .06" thick so it fit very well. Also we had some bugs in the laser cutter settings so it perforated the entire design instead of cutting it through. This actually turned out really well in the end because when I finally got it cut, the perforations acted as little "teeth" making the joints that much stronger.

I made a bit of a tradeoff in my design between ease of assembly and structural integrity. I intentionally offset the slots from the center so as not to compromise the center of the reed pieces which seems to already be a natural stress point. I'd like to do a little bit more research to see if this tradeoff is actually necessary.

Return to front

Older articles